1004 East Illinois Street Assumption, IL 62510 1-217-226-4421 Instructions 22" Rotary Unloader Valve Instructions Use supplied 3/8" x 1" bolts and 3/8" nuts for boot to bin collar connection. Use rope caulking around outside edge of holes. Do NOT get any caulking where rotary gate will be rotating. Ref # Part # Description 1 S-4378 Plastic Grip 2 HT-1353 Clean Out Plate 3 BLK-10921 Handle Weldment 4 S-4379 Shaft Shim 5 S-4377 Grooved Roll Pin 6 BLK-10994 Handle Bracket 7 BLK-10880 Frontplate Weldment 8 BLK-10340 Slotted Foam Gasket (Three (3) Pieces per Ring) 9 BLK-11096 Backplate Weldment 10 BLK-10871 Maxi-Flo Boot 11 Rotary Unloader Weldment 12 Rotary Gate Weldment 13 Bearing Cover Plate NOTE: Bearing kit is optional. Date: 10-12-15 V2.0 PNEG-057 Page 1 of 2 CN-314487 Printed in the U.S.A. Copyright 2015 by The GSI Group, LLC www.gsiag.com PNEG-057
22" Rotary Unloader Valve Instructions Unloader Tube Detail CLOSE OPEN Figure 1 Ref # A B C D Description 12" Connecting Band Assembly Cut Auger Tube Here (If Needed) Optional Bearing 23"-4" Unloaders 25"-6" Unloaders 27"-8" Unloaders Install optional bearing kit to unloader if ordered per supplied instruction sheet. NOTE: 4" Rotary unloaders require 23" of exposed flight. 6" Rotary unloaders require 25" of exposed flight. 8" Rotary unloaders require 27" of exposed flight. It may be necessary to field cut auger tube lengths to accommodate required exposures. After cutting (if necessary) butt tube to unloader tube and fasten with connecting band assembly. IMPORTANT: Unloader is designed to fit 4", 6" and 8" GSI/Hutchison feed tank augers. If using a different auger supplier, it may require field modification. PNEG-057 Page 2 of 2